IMPORTANT - Please ensure you have updated your ClockComms with daylight savings, time zones and definitions. See this guide here
Compatible devices - Z6 Series Time Clocks
As face clocks are our imported solution, we have a limited way in which we can configure daylight savings settings
Physical Configuration (Manual)
- Press M/OK
- Go to System
- Press M/OK
- Press M/OK to enter Date Time
- Go down until you see Daylight Saving Mode and ensure it is set to By date/time
- Go down
- Press M/OK to enter Daylight Savings setup
- Press M/OK on the Start date and change the date to accordingly
- Press M/OK
- Go down and press M/OK to enter a Start time. This should be set to 02:00.
- Press M/OK
- Go down and press M/OK to enter End Date and change the date to accordingly
- Press M/OK
- Go down and press M/OK to enter an End time. This should be set to 03:00.
- Press M/OK
- Press ESC
The Face Clock has now been set to change to daylight savings automatically
Remote Configuration
For this method to work, ClockComms needs to be running at the time daylight savings starts/ends. So ensure ClockComms is on a machine that will be able to stay online overnight eg Server.
Automatic (Repeat) Mode - (Click here to determine your ClockComms Mode)
- Press Ctrl + M
- Click on Repeat Mode
- On the Daily Events Column (Third Column), Click on the first checkbox and change the time to 03:30
- Ensure that Set Time and Date command is selected below
This sets the time to be updated to DST at 3:30 am provided your PC/Server time has automatically been updated with DST. - Click Save
Manual Mode - (Click here to determine your ClockComms Mode)
IMPORTANT: This will need to be done AFTER daylight savings has started (Not Recommended)
- Open ClockComms Utility
- Select Set time and date command
- Select Start
You have now updated your Face Clock with the correct Time and Date